Pocko 0 Posted May 8, 2012 Report Share Posted May 8, 2012 Hi I have same gun. I just held gun upright with my feet holding stock and used my hands to slowly twist it upwards. There was no glue or screws just grooves. But does look a bit ugly afterwards unless you get a silencer to cover it up :-) Quote Link to post
Pocko 0 Posted May 8, 2012 Report Share Posted May 8, 2012 Hi I have the stingray mk2 and managed to remove the front sight but I am now left with a section of barrel that is thinner than the rest? Could you recomend a moderator that would cover this whole section of the barrel? Thank's Quote Link to post
pete123 45 Posted May 9, 2012 Report Share Posted May 9, 2012 I had a Parker hale one but not sure which model best thing is to go into gun shop and try Quote Link to post
secretagentmole 1,701 Posted May 9, 2012 Report Share Posted May 9, 2012 (edited) Simple get a slip on UNF adaptor. It should cover that section up quite easily! Edited May 9, 2012 by secretagentmole Quote Link to post
Pocko 0 Posted May 9, 2012 Report Share Posted May 9, 2012 Thanks for the help guys, I think a trip to the gun shop is in order! I don't no why these manufacturers feel the need to completely modify the end of the barrel just for a plastic sight?! Lol Quote Link to post
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.