Help on making a silencer.

[fraggle 4]

Dose any one haave a link or a know how to make a home maid silencer, i already have the bit to screw on the barrel and the mod itself, just need to know how to make the inards. thanks all.

 

Fraggle.

[hiho 5]

isnt that classed as making a firearm!!

[Guest buster321c]

Dose any one haave a link or a know how to make a home maid silencer, i already have the bit to screw on the barrel and the mod itself, just need to know how to make the inards. thanks all.

 

Fraggle.

 

Is that the mod off the stingray mate ?

[00taz11 39]

get a coca cola bottle tape it onto the end of a gun and make a hole where the bullet will be leaving just something i seen on a film

[Scuzy 1]

isnt that classed as making a firearm!!

 

No.

[celticwar 1]

http://www.gun-shots.net/make-silencer.shtml

found this

[harry waudby. 10]

"get a coca cola bottle tape it onto the end of a gun and make a hole where the bullet will be leaving just something i seen on a film"

 

also seen it on a film called "shooter".

Edited October 26, 2008 by harry waudby.

[fraggle 4]

Dose any one haave a link or a know how to make a home maid silencer, i already have the bit to screw on the barrel and the mod itself, just need to know how to make the inards. thanks all.

 

Fraggle.

 

Is that the mod off the stingray mate ?

 

Yes mate, it is, just want to make the inards better.

Edited October 27, 2008 by fraggle

[hughesey1552 0]

without knowing to omuch on the subject mate i would say try using some styrofoam or macking foam u know, the stuff that u cut to shape. seems like a pretty good noise dampner to me.

[paddy.t 5]

How about expanding foam in some kind of pipe with a smaller piece of pipe inside then fill the gap with foam...

 

 

Good luck mate

Edited October 28, 2008 by paddy.t

[victor 10]

ive only been told lol, that you get a pipe mettal and spacers or washers that fit in side the tubing, you need 2 kindsa of washers/spacers, but thay both have to fit in the tubing. 1 needs a biger hole, 2 the outher type of washer needs a smallwer hole and put them in the pipein order of big hole small hole, untill you run oiut or are satified with eere your at. take wels the ends on and fit one end out with a screw type dealy with hole init and should be ok for you, hopw it makes sence and works if you give it a tey, if not sory to waist your time

[Jef66 0]

Heres a few links that might help out a bit

 

http://www.gun-shots.net/make-silencer.shtml

 

http://en.wikipedia.org/wiki/Suppressor

 

http://www.gunslot.com/blog/how-make-gun-s...ls-self-defense

 

http://www.geocities.com/austin_316_07/silencer.html