Jump to content

Yet another new court!


Recommended Posts


Exellent job there, on the blocks we use 1/2 inche blocks cut from strips of off cut shiplap, but the idea of plastic contiboard conectors is a good one and one I will look at using myself in the future, I have said this in the past, one thing about these site is some one always come up with ideas for thing that have been stairing us in the face for years and we just havn't seen them, always listern to knew ideas from others be they new to the sport or old hands

Link to post

Managed to get a bit done this evening, bought the mesh from a garden centre, never been there before, & by a hell of a coincidence, mentioned to the owner that it was for a ferret court, and he took us out the back and he had ferrets of his own! Two lovely jills, one sandy & one poley, and two hobs, one albino, one poley. He said he's had the albino hob for 10 years, someone gave it to him that had lost interest.

The poor old thing looked a right old state, moth eaten, dead skinny & nearly blind. The fella said he'd considered having him PTS, but he was still eating like a horse & chasing the jills about, (slowly!) and when he took him too the vet to have him checked out, he was fine apart from being old aged.

 

When I finished tonight it was nearly dark, but I couldn't resist moving them in, as they've all been cooped up in a large rabbit style hutch, and I didn't feel it was healthy for them.

 

post-8371-1215727441_thumb.jpg

 

Next job is to finish the concrete base & treat the timber, so I can move it to it's proper location, as the poor old wife had only just got her patio back again. If I don't do it quick, I'll be in the shite! :laugh:

 

Can anybody recommend a good preservative, that's not too pricey?

 

Cheers. :thumbs:

Link to post
Managed to get a bit done this evening, bought the mesh from a garden centre, never been there before, & by a hell of a coincidence, mentioned to the owner that it was for a ferret court, and he took us out the back and he had ferrets of his own! Two lovely jills, one sandy & one poley, and two hobs, one albino, one poley. He said he's had the albino hob for 10 years, someone gave it to him that had lost interest.

The poor old thing looked a right old state, moth eaten, dead skinny & nearly blind. The fella said he'd considered having him PTS, but he was still eating like a horse & chasing the jills about, (slowly!) and when he took him too the vet to have him checked out, he was fine apart from being old aged.

 

When I finished tonight it was nearly dark, but I couldn't resist moving them in, as they've all been cooped up in a large rabbit style hutch, and I didn't feel it was healthy for them.

 

post-8371-1215727441_thumb.jpg

 

Next job is to finish the concrete base & treat the timber, so I can move it to it's proper location, as the poor old wife had only just got her patio back again. If I don't do it quick, I'll be in the shite! :laugh:

 

Can anybody recommend a good preservative, that's not too pricey?

 

Cheers. :thumbs:

if you can afford it have a look at johnsons opaque wood finish or johnsons shed and fence - dont go to cheap some of the shed and fence paint is like piss .. google johnsons or leyland paint you should find a spec-- any leyland paint stores should stock it :yes:
Link to post

youve done a top job there... :clapper:

 

one thing i would do before putting wood preservative on is apply some " ronseal wood hardener " at the lower base of the sides where the edges touch the concrete. this will give a permanent seal.

 

 

did you concider using marine ply ? more expensive but no need to use a wood preservative & wouldnt soak the water up.

 

http://www.screwfix.com/prods/63540/Paint/...500ml?source=aw

 

rich

Link to post

great looking set up, I too would go with it raised up on a layer or two of bricks, otherwise the bottom will start rotting, even with preserve in a matter of years, you could still leave gaps in the brickwork as a drain away when hosing out, :thumbs:

Link to post
youve done a top job there... :clapper:

 

one thing i would do before putting wood preservative on is apply some " ronseal wood hardener " at the lower base of the sides where the edges touch the concrete. this will give a permanent seal.

 

 

did you concider using marine ply ? more expensive but no need to use a wood preservative & wouldnt soak the water up.

 

http://www.screwfix.com/prods/63540/Paint/...500ml?source=aw

 

rich

 

Marine ply is mega expensive round here, your looking at something like £50 a sheet, :icon_eek: that would have been around £150 just for the 3 sheets I used. It's meant to be WBP (weather & boil proof) ply, it's not as waterproof as marine ply, but it's the next best thing. It'll get wet, but the glue inside it is supposed to waterproof.

 

I might well build a course of bricks onto the slab at some point in the future, but for now I've made little feet with DPM sandwiched between two pieces of ply. The damp you can see rising up the sides, it what's left after I'd left it directly on the patio the first night I put it together. It's dried out a fair bit since I put it up on the little blocks.

 

Cheers for the replies & the ideas. :thumbs:

Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...