bsa super ten

[gandalf 0]

hi lads/lasses

hope some one can help me here.i unscrewed the buddy bottle on my super ten only to find the cartridge it screws on to came out also never seen the inside of an air gun before so carefully removed the 2 screws and safety switch to get to the inside screwed the cartridge back on to the part it came off and reassembled the gun.put a full buddy bottle back on and everything was fine untill that needed replacing.tried unscrewing it off and the same again the part inside came with it.had to go through the whole thing again.question

1, if i used 2 clamps to screw the two internal parts together could i over tighten them

2, am i screwing the buddy bottle too tight onto the gun ie am i using to much force or does it only need to be screwed on untill there is little resitance any one have any ideas i would like to hear from you

thanks all

[CRAIG21 3]

i had this problem i just put a little bit of lock tight then tightend on firm

[SEAN3513 7]

may also help to grease the 'o' ring on your buddy bottle.

 

just check on the theoben website........special grease i think????

 

cheers

 

sean

[gandalf 0]

thanks lads

[Coney 3]

thanks lads

 

 

Did you get sorted???

[gandalf 0]

thanks lads

 

 

Did you get sorted???

no not home untill friday offshore at the mo be shitfaced when i get home so i will do it on saturday gonna try greasing the o rings first see if that works before i put any glue on let you know what happens happy hunting