shotgun firing pin

[pengelli 371]

hello just after some advice got a 12 gauge o/u spanish made shotgun and the firing pin on the top barrel needs replaced i think its the pin as its not striking the primer on the cartridge or even my finger tip when i hold it against it is this something i can fix myself or would a gunsmith be needed thanks 

[neil82 1,080]

If your not 100% confident with anything that goes bang, give it to someone who is, gunsmith should not be that expensive to replace the pin if needed and give the rest of it a once over at the same time.

[pengelli 371]

cheers mate thanks for the reply 

[elf847 1]

I'd advise you give it to someone that specialize in fixing it. It won't cost you a lot..

[ditchman 2,843]

treat firing pins like shock absorbers....never change one ...do both........the smith i used preferred to make new pins he would harden and temper them..it was never expensive

[pengelli 371]

cheers mate 

[paulus 26]

Always made my own from old carbide drill bits, it could even be as simple as needing a spring replacing. 

[Meece 1,957]

Since when has taking a gun in for examination and repair been cheap.?  With the current low,low price of guns unless it is at least a middle range gun it won't be worth repair.  It's like modern cars.  Any car over 3 years old doesn't have to have much of a bump to be classed as a write off.  Can't see any gun reparer stripping a gun, and fitting  one, or both pins and springs and giving it a clean reassembly for less than a couple of hundred.  The days of a tenner are way gone.