tomburras 2,730 Posted December 2, 2023 Report Share Posted December 2, 2023 Hi guys! Iv had this stormrider a while now as standard. I fitted an altaros regulator but it was set too high (great reg but markings where innacurate) Iv had it apart maybe 8 times in the last few weeks. After much messing about I got the reg as low as possible.... Quote Link to post
tomburras 2,730 Posted December 2, 2023 Author Report Share Posted December 2, 2023 With a 3mm transfer port and a ultra light hammer spring (1mm soft wire from china) After butchering many springs (good job I baught 10) flattened and polished the end of the hammer spring. I got it set with zero preload and shimmed the valve spring 5mm and I'm getting 70 shots at 11+ ft lbs. For anyone looking for a tinkering project id reccomend one. It was just over £200 quid I think. I baught instead of a hw99. Quote Link to post
tomburras 2,730 Posted December 2, 2023 Author Report Share Posted December 2, 2023 Also fitted a custom bolt and 3d printed swing out single shot loader. It's pellet on pellet with biz mags at 30 yards. Also has a hw moderator. Great little gun! I'd reccomend one. It was good standard but I was only getting 35 shots per fill and inconsistent as standard. Quote Link to post
elf847 1 Posted December 4, 2023 Report Share Posted December 4, 2023 Nice setup. Thanks for sharing 1 Quote Link to post
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.