FOXHUNTER 5,021 Posted November 9, 2023 Report Share Posted November 9, 2023 Annoying problem with my toilet. It flushes fine and refills Ok but every now and then it decides to make a flushing noise and refill a small amount of water. Everything looks fine to me , anybody any ideas? On the below pic I have marked where water slowly seeps through . I have wedged a piece of cardboard at the edge of the ring just to see if this works. Any advice as its pi$$ing me off Quote Link to post Share on other sites
MH1 1,847 Posted November 9, 2023 Report Share Posted November 9, 2023 I had something similar with the flushing and filling up. Turned out to be the seal between the cistern and the bowl had degraded so was letting water through slowly into the bowl to the point it would need to fill up again. 1 Quote Link to post Share on other sites
Daniel cain 44,410 Posted November 9, 2023 Report Share Posted November 9, 2023 Cost you around £20/30 to replace the whole unit,turn off the water and remove the old one... match it up at the merchants etc ,you wont need to pay a plumber, piece of piss to do Toilet Cisterns | Toilet Cistern Parts | Wickes WWW.WICKES.CO.UK Need a toilet cistern? Get trade quality cisterns and cistern parts at low prices. Quality assured since 1972. Visit our... Parts list In above link. 6 Quote Link to post Share on other sites
chartpolski 22,407 Posted November 9, 2023 Report Share Posted November 9, 2023 Change the flushometer, ball valve and donut all at the same time. Cheers. 1 Quote Link to post Share on other sites
Bobtheferret 1,237 Posted November 9, 2023 Report Share Posted November 9, 2023 Be best to just change the ball valve although it may be the siphon letting by very slowly. Can you see water running down the inside of the toilet? If it’s trickling water through then it will need to replace the water it’s lost causing the ball valve to open. Ball valve is easy on those concealed cisterns the siphon a little harder but still not to bad. Quote Link to post Share on other sites
cragman 2,748 Posted November 9, 2023 Report Share Posted November 9, 2023 Did mine recently, just as DC has said, easy enough. If I can do it…. Quote Link to post Share on other sites
FOXHUNTER 5,021 Posted November 9, 2023 Author Report Share Posted November 9, 2023 35 minutes ago, Bobtheferret said: Be best to just change the ball valve although it may be the siphon letting by very slowly. Can you see water running down the inside of the toilet? If it’s trickling water through then it will need to replace the water it’s lost causing the ball valve to open. Ball valve is easy on those concealed cisterns the siphon a little harder but still not to bad. No water running down inside of toilet. Looks like a new ball valve then , flush was replaced a couple of years ago Quote Link to post Share on other sites
chartpolski 22,407 Posted November 9, 2023 Report Share Posted November 9, 2023 39 minutes ago, Bobtheferret said: Be best to just change the ball valve although it may be the siphon letting by very slowly. Can you see water running down the inside of the toilet? If it’s trickling water through then it will need to replace the water it’s lost causing the ball valve to open. Ball valve is easy on those concealed cisterns the siphon a little harder but still not to bad. It's false ecomomy to just change one part. You can bet your life another part will fail within weeks. Best to change the flometer, ball valve and donut all in one go when the water is off and the cistern is in bits. The parts are so cheap it makes sense . Cheers. 2 Quote Link to post Share on other sites
Daniel cain 44,410 Posted November 9, 2023 Report Share Posted November 9, 2023 1 hour ago, chartpolski said: It's false ecomomy to just change one part. You can bet your life another part will fail within weeks. Best to change the flometer, ball valve and donut all in one go when the water is off and the cistern is in bits. The parts are so cheap it makes sense . Cheers. Words of wisdom them Charts Could change the whole cistern,to an all singing and dancing for 50/60 notes...piece of mind... A new toilet and sink basin only £100 if you shop around 2 Quote Link to post Share on other sites
Greyman 27,300 Posted November 10, 2023 Report Share Posted November 10, 2023 23 hours ago, FOXHUNTER said: Annoying problem with my toilet. It flushes fine and refills Ok but every now and then it decides to make a flushing noise and refill a small amount of water. Everything looks fine to me , anybody any ideas? On the below pic I have marked where water slowly seeps through . I have wedged a piece of cardboard at the edge of the ring just to see if this works. Any advice as its pi$$ing me off It’s just an O ring gone in that big gnurled screw on bit, new O ring or a bit of silicon on the thread see you right if you don’t fancy changing out the siphon 1 Quote Link to post Share on other sites
Bobtheferret 1,237 Posted November 10, 2023 Report Share Posted November 10, 2023 20 hours ago, chartpolski said: It's false ecomomy to just change one part. You can bet your life another part will fail within weeks. Best to change the flometer, ball valve and donut all in one go when the water is off and the cistern is in bits. The parts are so cheap it makes sense . Cheers. That toilet doesn’t even have a donut mate. As a plumber of 25 years I generally agree with you but in this occasion changing the ball valve is easy the rest not so much it’s a concealed cistern in a boxing so potentially you have quite the job changing the siphon depending on the set up of the toilet. Quote Link to post Share on other sites
Bobtheferret 1,237 Posted November 10, 2023 Report Share Posted November 10, 2023 21 hours ago, FOXHUNTER said: No water running down inside of toilet. Looks like a new ball valve then , flush was replaced a couple of years ago If the siphon (flush) is newish then just change the ball valve and see if that cures it. As said if reply above the rest is potentially quite complicated so start there. Quote Link to post Share on other sites
chartpolski 22,407 Posted November 10, 2023 Report Share Posted November 10, 2023 8 minutes ago, Bobtheferret said: That toilet doesn’t even have a donut mate. As a plumber of 25 years I generally agree with you but in this occasion changing the ball valve is easy the rest not so much it’s a concealed cistern in a boxing so potentially you have quite the job changing the siphon depending on the set up of the toilet. I was speaking generally, I couldn’t tell what type of cistern that was. I look at it a bit like brakes or track rod ends on a car, I wouldn’t just change one side, I’d do both while I had the tools out and the car on jacks. Same with a cistern, it would only take minutes more to change all the components while you were at it, and the extra cost is negligible and you’ve got peace of mind that one of the other components isn’t going to fail in the near future, but I bow to your experience. Cheers. Quote Link to post Share on other sites
FOXHUNTER 5,021 Posted November 10, 2023 Author Report Share Posted November 10, 2023 I was speaking to a guy at work today who used to be a plumber , he said just replace the inlet valve. I suggested he could do it for me to which he agreed......Result Quote Link to post Share on other sites
Borr 5,282 Posted November 10, 2023 Report Share Posted November 10, 2023 Result saved yourself £10. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.