Gaz_Lurcherlad 382 Posted April 2, 2020 Report Share Posted April 2, 2020 Not the best job but it will do strong as owt see how it goes need to cut mouth down 1 Quote Link to post
Squirrel_Basher 17,100 Posted April 3, 2020 Report Share Posted April 3, 2020 I take it your not going into production any time soon 1 Quote Link to post
Gaz_Lurcherlad 382 Posted April 3, 2020 Author Report Share Posted April 3, 2020 1 hour ago, foxdropper said: I take it your not going into production any time soon No mate an I went to uni for 18month on welding and fab course lol I clearly don’t listen the m20 nuts on the ends don’t actually do anything it was just to get them to screw together flush , either half has been filled will a solid bar drilled and tapped one side and screwed threaded bar in and drilled in and spot welded it the stop it twisting out and other side just tapped and there we go looks terrible but works Quote Link to post
Squirrel_Basher 17,100 Posted April 3, 2020 Report Share Posted April 3, 2020 Few digs will tell you more ,looks solid enough . Quote Link to post
Atkinson 0 Posted May 25, 2020 Report Share Posted May 25, 2020 Is this just a bolt welded to bottom of shaft? Looks well to be honest Quote Link to post
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.