Mattyulph 2 Posted October 25, 2019 Report Share Posted October 25, 2019 Hi guys first or second post just wondering if anybody knows about the prestige kub or where to find parts In need of a exhaust valve I think as when the pressure in the rifle gets to about 100 bars then it gets a slow leak from the barrel or is there any other solution. Thanks for reading Quote Link to post
philpot 4,966 Posted October 25, 2019 Report Share Posted October 25, 2019 Hi Matt I know nothing about these guns I am afraid but I am sure one of our clever lads will be along soon. These guys might be able to help you. https://spares.bagnallandkirkwood.co.uk/prestige-2/prestige-kub-air-rifle-gun-spare-parts-list/ Phil Quote Link to post
Mattyulph 2 Posted October 25, 2019 Author Report Share Posted October 25, 2019 Thanks for the reply phil I've messeged them just waiting on reply thanks again Quote Link to post
Rez 4,957 Posted October 25, 2019 Report Share Posted October 25, 2019 Alight Matt. Same as Phil. Seen a couple in the past, but never even held one. To be honest your the only member to mention the kub (it’s got the rimmy style bolt if my memory serves me right) since I’ve been a member me sen. Got any pics like? Out of interest. Quote Link to post
Mattyulph 2 Posted October 26, 2019 Author Report Share Posted October 26, 2019 I have rez at the min it's at a mates house he's using it but just didn't seem to hold pressure below the 100 bar or so I'll try get a couple of photos for you 1 Quote Link to post
Premier Pistol 30 Posted November 7, 2019 Report Share Posted November 7, 2019 Worked on a few of these, they are good guns with little following as they were rather expensive new, somewhat more than the average AA S410 i seem to remember. the valve parts are very similar to the FX built Webley Axsor guns but not directly interchangeable. I usually make a new valve stem and seat to fit the gun which fixes it. the problem often is down to valve and main springs not being matched so at lower pressures the hammer sits on the valve stem and manages to overcome the weak valve spring and the pressure in the cylinder, which means the air all jets out. this is particularly prevalent in aftermarket regulated rifles where the correct steps have not been taken to balance everything up. anyway, if you'd like it repaired, send it up to me and I'll get it fixed up. Quote Link to post
Mattyulph 2 Posted November 7, 2019 Author Report Share Posted November 7, 2019 Thanks alot premier pistol I'll have another look and if no joy I'll get back to you thanks again Quote Link to post
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.