Hw100Kt Out Of Warranty

[Gary73 62]

Just realised my hw100kt is now just over 12 months old, so decided to remove AT and setup so that I can adjust if required with ease in the future.

 

Nice thread on Airgun forum helped. Pretty easy to do.

 

http://www.airgunforum.co.uk/forums/showthread.php/182879-hw100-stripdown-service

 

Now doing with JSB exact rs 13.43gr in fps. 12fps spread.

 

612

613

609 11.06 ft/lbs

615

618

617

614

621 11.5 ft/lbs

619

618

617

612

617

614

 

 

[toby63 1,236]

have you tried different pellets through same chrono see if you can get the spread down abit . did mine few week ago and doing 3fps spread over 10 shots using 16 g aa fields from 200 bar fill

[Gary73 62]

Not yet, thought I would put a few mags through and when the reg pressure tester turns up set that and then re-check power.

 

I can live with a 12fps spread, its about the same as my Steyr and R10 in that respect.

[Gary73 62]

Just serviced my hw100kt .22 after removing the anti tamper on Sunday.

 

Reg pressure tester arrived this morning from the factory my reg was doing 98bar. So I took the belleville washers out cleaned them and the area surrounding and put it back together.

 

I adjusted it down to 90bar and fired it a few times to ensure it went back to 90bar and it reacted quickly after the shot. Set it up doing 610fps with faps. Put it all back together and zero'd at 25 yards and it put all the pellets through the same pellet hole.

 

14 shots over the chrono revealed and spread of 11fps checking the forums that is normal for a hw100kt .22 with pellets straight from the tin.

 

Job done

[toby63 1,236]

nice one its sorted now

[Gary73 62]

A plus side was the 0.4ft/lbs between 15.9gr pellets and 13.43gr pellets has been reduced to 0.1ft/lbs which is nice.