BIGLURKS 874 Posted June 11, 2015 Report Share Posted June 11, 2015 Right need a bit of a hand here I've got a kawazaki 250 that's been running ruff carbs fine but the air filter is a bit dirty so pulled it off can any one tell me if I can clean it or does it need a new one rather not buy one it's kinda foamey type not the cardboard type is it k too wash them Quote Link to post Share on other sites
jeppi26 1,855 Posted June 11, 2015 Report Share Posted June 11, 2015 With the state that's in ad buy a new one Quote Link to post Share on other sites
BIGLURKS 874 Posted June 11, 2015 Author Report Share Posted June 11, 2015 With the state that's in ad buy a new oneis it washable though not got a lot of money coming in at the moment would rather save it if I can Quote Link to post Share on other sites
budgie123 163 Posted June 11, 2015 Report Share Posted June 11, 2015 Wash with petrol allow to fully dry re coat with oil{engine oil} job done. I was adviced to clean with petrol by honda main dealer even though manual says not. 2 Quote Link to post Share on other sites
moxy 617 Posted June 11, 2015 Report Share Posted June 11, 2015 Wash with petrol allow to fully dry re coat with oil{engine oil} job done.I was adviced to clean with petrol by honda main dealer even though manual says not. How does it tick over without the filter on? Quote Link to post Share on other sites
moxy 617 Posted June 11, 2015 Report Share Posted June 11, 2015 Did you clean out the float valve? Quote Link to post Share on other sites
BIGLURKS 874 Posted June 12, 2015 Author Report Share Posted June 12, 2015 Wash with petrol allow to fully dry re coat with oil{engine oil} job done. I was adviced to clean with petrol by honda main dealer even though manual says not. thx budgie is atv engine oil fine just brush it on aye Quote Link to post Share on other sites
BIGLURKS 874 Posted June 12, 2015 Author Report Share Posted June 12, 2015 Did you clean out the float valve?Not yet mate not had a day too sit down and do it yet been cleaning the frame for a repaint some of the joints and welds are starting too rust up so needing a sand blaster cos the wire brush is not going too hack it Quote Link to post Share on other sites
budgie123 163 Posted June 12, 2015 Report Share Posted June 12, 2015 yes mate atv engine oil. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.