Jump to content

Recommended Posts

A friend of mine has hatched out 2 dozen Light Sussex chicks,they were hatched in two batches one two weeks old now,one three.Over the last few days 3 of the chicks have gone off one leg,they almost look like they are twisted 90 degrees...the chicks affected are 2 of one clutch and 1 of the other so its both sets of chicks.Been perfectly fine up until now...any ideas please :thumbs: Thanks, Dave

Link to post
Share on other sites

Mareks is a curse, real horrible thing. Although it causes paralysis it usually comes with a few different symptoms along with it (in my experience)

 

Could it be splay leg or something similar? They can get this from living on a slippy surface.

 

 

I had a chick from my first ever hatch have his leg slowly twist from the middle to the foot out wards - tried to no avail to fix it. He lived for months and months on one leg happily then died of a different cause. But if I could go back I may well have culled him as it was bound to be a bourdon on him.

 

Called him leg :laugh: ah that's awful lol

Link to post
Share on other sites

Thanks for the replies guys :thumbs: I don't think its Mareks,I don't know that much about chickens but that was my first thought,theres no other symptoms at all :hmm: Mo it could be splay leg..I had a quick look at them last night whilst checking some traps,theyre in no pain with it you can move the leg/ feet around causing no distress to the chick so its possible.Theres no slippery surface by the way theyre in clover this lot :yes: nice shed plenty of light /heat etc will have a look in later RIP Leg :cray::laugh:

  • Like 1
Link to post
Share on other sites

Incubator... two separate ones,same parents one clutch a week older than the other :hmm:

this may sound silly but I'll throw it in the mix.

 

Does the incubator have a tray at the bottom? Is it plastic.

 

I know mine has the turner then under there's the tray which is plastic very slick surface I tend to line it to stop these issues.

Link to post
Share on other sites
Guest Navek

Think I read somewhere that fluctuating temperatures in the incubator while the chick is first developing can result in deformed legs/ feet....but does sound like splayed leg..but then again splayed leg is caused by a slippery service and if there in a shed with sawdust or straw then this is very unlikely the case and if the incubator floor surface caused this it would of happened in the incubator not a couple of days later surely .........hmmmm tricky one this

Link to post
Share on other sites

 

Incubator... two separate ones,same parents one clutch a week older than the other :hmm:

this may sound silly but I'll throw it in the mix.

 

Does the incubator have a tray at the bottom? Is it plastic.

 

I know mine has the turner then under there's the tray which is plastic very slick surface I tend to line it to stop these issues.

 

One clutch did Mo...one didn't :thumbs:

 

Think I read somewhere that fluctuating temperatures in the incubator while the chick is first developing can result in deformed legs/ feet....but does sound like splayed leg..but then again splayed leg is caused by a slippery service and if there in a shed with sawdust or straw then this is very unlikely the case and if the incubator floor surface caused this it would of happened in the incubator not a couple of days later surely .........hmmmm tricky one this

They are in a roomy shed with shavings on the floor,no slippery surfaces :thumbs:

 

Where they running around fine for the two weeks after they left ye incubator?

 

Where they running around fine for the two weeks after they left ye incubator?

Absolutley fine until a few days ago :thumbs: Strange one indeed .....cmon think harder,THL braintrust :laugh: Thanks for replies :thumbs:

Link to post
Share on other sites

I'm gonna agree with budharley on this one. Splayed legs can be treated, but it's a defect, and could resurface later down the line. Depends on you really, time, feed etc.

I was thinking slippery surface in incubator myself, but as stated this as happened further down the line.

Stumped I am.

Atb

  • Like 1
Link to post
Share on other sites

Cheers guys :thumbs: If they were mine Id cull them tbh,and I think he will any way,just thought Id ask incase it was something obvious that could be fixed/prevented,if theres any further developments I will keep you posted,thanks for the input :thumbs: ATB Dave

  • Like 1
Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...