Calibrating Mk1 Ferret Finder

[Loton Moocher 1,254]

you cant beat the old mk 1 knocker boxes

 

[elliotmcc 67]

Need a mk1 knockerbox repaired, any recommendations? Tried the knockerbox shop on facebook but i think they are a bit snowed under at the minute 

[big napper 3,570]

Anyone have a number to get locaters fixed, not jim chick or david aurthers please as iv tryd those numbers, thanks for any replys

[Arry 21,483]

1 hour ago, big napper said:

Anyone have a number to get locaters fixed, not jim chick or david aurthers please as iv tryd those numbers, thanks for any replys

This is off the PigionWatch forum. I don't know if he on here.

 Mick Dadd 01142 851372 

Cheers Arry

[big napper 3,570]

Nice one arry, cheers pal il ring him now

[big napper 3,570]

Jist phoned him arry, he cant get the parts as the bloke he got them from has died, he is trying to get another supplier so il ring him back in a month or so unless someone knows someone else that does them

[Arry 21,483]

On 17/11/2018 at 15:05, big napper said:

Jist phoned him arry, he cant get the parts as the bloke he got them from has died, he is trying to get another supplier so il ring him back in a month or so unless someone knows someone else that does them

Sorry mate only just seen this reply. 9 times out of 10 the boxes fail due to the on/off switch depth finder, these can bought of eBay.

https://www.ebay.co.uk/itm/Ferret-Finder-on-off-depth-switch-Deben-Terrier-Locator-/254002432267

If you can solder or know anybody that can solder.

Take battery off, take the screw out from centre of the depth wheel then remove the circuit board out of the box. Desolder speaker, now the dog can see the rabbit so to speak. The depth/ on/off switch has five pins. Will help if you have solder wick,  

https://www.ebay.co.uk/bhp/solder-wick

Place solder wick next to one of the pins on the opposite side to the switch, put the hot soldering iron on top and it will sort of suck the solder out of the hole repeat to the other 4 holes. then wiggle the old switch off the board, may need to repeat the wicking if it will not come out. Push the new switch in making sure its all the way in, this is important as the wheel will not line up with the slot in the box else. Run solder in each hole, re-solder the speaker back on. Hope this may help.

Cheers Arry

[big napper 3,570]

Cheers for that arry, i got in touch with a lad called paul in lancashire and i sent the 3 boxes off to him last week, hopefully all will get sorted. Thanks again pal

[RTurlough 160]

hey Big Napper, any chance of Pm'ing me that number of the lad in lancashire?  

[big napper 3,570]

Done mate

[Robert Hetherington 3]

any chance of putting the details on here or do they wish to remain quiet would be good to have someone else to go to after the sad news about jim.

[big napper 3,570]

Il put it on the ferreting section mate

[big napper 3,570]

Knockerbox repairs, Lancashire, paul 07791879579, does leather collars ect aswell.

[big napper 3,570]

On 08/02/2019 at 17:39, big napper said:

.

[maxwell 88]

Is Paul Sullivan still doing work on the mk1 boxes