Gtbaker369 44 Posted March 31, 2015 Report Share Posted March 31, 2015 Just a quick one again. I've seen and heard people using different amounts of therband gold on the catties. Would a single length be enough to kill somet or would you have use at least 2? Just wondering that's all Quote Link to post Share on other sites
1Wally 204 Posted March 31, 2015 Report Share Posted March 31, 2015 Singles fine with lighter ammo. Perfect for m-8 hex nuts. Quote Link to post Share on other sites
Gtbaker369 44 Posted March 31, 2015 Author Report Share Posted March 31, 2015 I'm right in saying I should trim all edges of the piece I get before start cutting strips? People have recommended 20-25mm width but if me forks are smallish will I be alright to cut them to fit forks? Quote Link to post Share on other sites
carlstoke 34 Posted March 31, 2015 Report Share Posted March 31, 2015 Single cut 30-25 great fpr 10mm lead. Quote Link to post Share on other sites
Gtbaker369 44 Posted March 31, 2015 Author Report Share Posted March 31, 2015 Is there a guide line length to begin with before I start decreasing by inch till get to nearly maxing out at anchor? Quote Link to post Share on other sites
Longers7 720 Posted March 31, 2015 Report Share Posted March 31, 2015 Measure your draw length by holding a tape measure in hand that you hold your catty then pull tape out to your anchor point, then divide that number by 4, you shouldn't be far off, my draw length is 32" so I cut flats at 8" long , hope this helps Quote Link to post Share on other sites
Gtbaker369 44 Posted March 31, 2015 Author Report Share Posted March 31, 2015 Helps a lot mate thank you Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.