relic2 19 Posted February 7, 2015 Report Share Posted February 7, 2015 screw eyes for tube shooter does the screw go the full lengh of the fork & do you glue them in cheers Quote Link to post Share on other sites
carlstoke 34 Posted February 7, 2015 Report Share Posted February 7, 2015 The screw does not need to go the full length of the fork unless you forks are very low, just drill a pilot hole slightly smaller than the screw thread fill with epoxy job done. do not try to force into to small a pilot hole as this may split the fork, hope this helps. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.