robbo 851 Posted January 5, 2015 Report Share Posted January 5, 2015 as an electrician of 35 years i can honestly say that as long as the correct breaker is used to supply the cable [i.e. 20 amp for 2.5mm] and it is protected by an rcd there is nothing wrong with using flat twin and earth to supply a shed or garage. it has to be installed properly using a catenary wire or conduit etc. to support it and the length of the run has to be taken into account to keep volage drop to an acceptable level. it should also have an rcd mains [garage kit] installed at the shed as this is a detached building. as for just using an extension , this is fine you just need to make sure it is plugged into an rcd protected socket. it isnt the best method but isnt a danger to life so long as its protected. Thousands of older houses still have old rewireable fuse boxes so check yours has an rcd if not buy one of the plug in types[powerbreaker] 1 Quote Link to post Share on other sites
General lee 979 Posted January 5, 2015 Report Share Posted January 5, 2015 Just get a wire put a plug on it run to the garage and plug it in Quote Link to post Share on other sites
Rabbithunter 456 Posted January 5, 2015 Report Share Posted January 5, 2015 make an extension lead with whatever size you want,..... aslong as the "fuse" is the "weakest link" in the circuit its no good putting a 13amp fuse in the plugtop if the cable isn't rated for 13amp, as the cable would burn out before the fuse! 1 Quote Link to post Share on other sites
Rabbithunter 456 Posted January 5, 2015 Report Share Posted January 5, 2015 robbo, on 05 Jan 2015 - 08:14 AM, said:as an electrician of 35 years i can honestly say that as long as the correct breaker is used to supply the cable [i.e. 20 amp for 2.5mm] and it is protected by an rcd there is nothing wrong with using flat twin and earth to supply a shed or garage. it has to be installed properly using a catenary wire or conduit etc. to support it and the length of the run has to be taken into account to keep volage drop to an acceptable level. it should also have an rcd mains [garage kit] installed at the shed as this is a detached building. as for just using an extension , this is fine you just need to make sure it is plugged into an rcd protected socket. it isnt the best method but isnt a danger to life so long as its protected. Thousands of older houses still have old rewireable fuse boxes so check yours has an rcd if not buy one of the plug in types[powerbreaker] my kennels are powered from my C.U on a 32a mcb, on a split load board, protected with rcds.... the cable is 6mm t+e in metal conduit underground, then continued in metal conduit up the kennel wall and terminated into a small C.U .... it powers 1 fluro 1 Quote Link to post Share on other sites
villaman 9,983 Posted January 5, 2015 Report Share Posted January 5, 2015 I think few on here should read the 17th edition of the wiring regulations or the on site guide 1 Quote Link to post Share on other sites
General lee 979 Posted January 5, 2015 Report Share Posted January 5, 2015 Think a few on here need to just get on with it just run the wire out and plug it in haha Quote Link to post Share on other sites
robbo 851 Posted January 6, 2015 Report Share Posted January 6, 2015 robbo, on 05 Jan 2015 - 08:14 AM, said:as an electrician of 35 years i can honestly say that as long as the correct breaker is used to supply the cable [i.e. 20 amp for 2.5mm] and it is protected by an rcd there is nothing wrong with using flat twin and earth to supply a shed or garage. it has to be installed properly using a catenary wire or conduit etc. to support it and the length of the run has to be taken into account to keep volage drop to an acceptable level. it should also have an rcd mains [garage kit] installed at the shed as this is a detached building. as for just using an extension , this is fine you just need to make sure it is plugged into an rcd protected socket. it isnt the best method but isnt a danger to life so long as its protected. Thousands of older houses still have old rewireable fuse boxes so check yours has an rcd if not buy one of the plug in types[powerbreaker] my kennels are powered from my C.U on a 32a mcb, on a split load board, protected with rcds.... the cable is 6mm t+e in metal conduit underground, then continued in metal conduit up the kennel wall and terminated into a small C.U .... it powers 1 fluro i think you might have overegged it there mate. 1 Quote Link to post Share on other sites
robbo 851 Posted January 6, 2015 Report Share Posted January 6, 2015 I think few on here should read the 17th edition of the wiring regulations or the on site guide I have mate Quote Link to post Share on other sites
Rabbithunter 456 Posted January 6, 2015 Report Share Posted January 6, 2015 does the 17th edition cover extension leads then Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.