Gas Ram Help

[jeemes 4,596]

Looking for someone to lower gas ram power. Can anyone point me in the right direction please?

[dhand62362 13]

I took mine to a gun smith as I didn't have a pump, sometimes the valve needs replacing

 

Try SFS if its local as Tony offered to lower mine

[andyfr1968 772]

What rifle is it, mate?

[dhand62362 13]

mine is a sirocco

Edited November 2, 2013 by dhand62362

[ukhunter 111]

at the rear of your action theres a small allen bolt or screw head, depending on year or your Sirocco?.

under this is a shraeder valve. Its a simple matter of REDUCING pressure in the ram just tap the schrader valve ONCE

with a drifting pin and hammer It takes only a few taps to reduce ft lb quite a bit. then i would re chrono it mate.

 

 

[jeemes 4,596]

mine is a sirocco

why dont you start your own thread ? Every time i ask this question i get someone butting in and side tracking.

[kanny 21,095]

Have a look on ]http://Theoben-Rapid.co.uk

everything you will ever need to know about theoben rifles including gasram strip downs and rebuilds

 

Atb

 

Kanny

Edited November 3, 2013 by kanny

[jeemes 4,596]

Have a look on ]http://Theoben-Rapid.co.uk

everything you will ever need to know about theoben rifles including gasram strip downs and rebuilds

 

Atb

 

Kanny

ok i will thanks

[andyfr1968 772]

Hello mate and cheers for the PM.

 

ukhunter's answered it spot on. Just make sure when you tap the valve (gently) that you only release a very small amount of air at a time and you will need a chrono.

 

Good luck.

Edited November 3, 2013 by andyfr1968

[jeemes 4,596]

Hello mate and cheers for the PM.

 

ukhunter's answered it spot on. Just make sure when you tap the valve (gently) that you only release a very small amount of air at a time and you will need a chrono.

 

Good luck.

cheers. Im going to have a go.