air gun ant 1,666 Posted September 11, 2013 Report Share Posted September 11, 2013 been doing a bit of welding recently (as most landy owners probably do lol) and wondered if i could make myself a rear step and weld it to the crossmember or is there certain boxes it has to tick? ie folding, locking down, does it have to be bolted on or is welding ok? cheers folks ant Quote Link to post Share on other sites
neil82 1,080 Posted September 11, 2013 Report Share Posted September 11, 2013 make it a bolt on job, use towbar mounting points and keep the size sensible, if it sticks out too much just get some reflective tape to act as a marker, should be ok Quote Link to post Share on other sites
04fox8 168 Posted October 12, 2013 Report Share Posted October 12, 2013 Just Buy one. They Cost little more than a tenner from Paddocks. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.