Aa S200 Mk2 Scope Trouble

[jandcguns 65]

ill ask again ...... i have an aa s200 i knocked it of my bench rest on to the floor from a height of about 8" and the gun now shoots about 1" high and 1"-1and a half " to the right and the scope has ran out of clicks, just want to know can i fix this i hope i can any help would be appreciated thanks,,jack

[Phantom 631]

Yes Jack, you can.

I have also done similar!

What is liked to have happened is either, you have knocked the scope out of alignment or more likely the barrel has been jarred a little.

Remove the scope. Loosen the Allen screws on the top of the block (2 screws) . Push the barrel right in and re-tighten.

If you use the small block on the barrel to mount your scope, you may need to loosen and reset the screw on that.

 

Finally, the screw under the barrel band on the forestock may need tightening.

Any more help, gimmie a yell

 

Tony

[smoothfinish 26]

Hope you get it sorted bud i would of been wounded if id of done that if i get a little mark on mine the polish comes out till spotless lol

[jandcguns 65]

thanks phantom i will give that a go,and luckly there no damage to the stock

[jandcguns 65]

i think ive found out whats went wrong the screw in the bottom of the barrel clamp is sort and dose not tighten and always falls out i think ive snaped the screw whem it fell causing the barrel to move, so im looking to buy a new screw any ideas and where to get one will try Chambers

[Craig Fosse 286]

If not try putting air arms s200 in ebay, u can get them off their, although I haven't tested them mate