A1WOC 212 Posted March 16, 2013 Report Share Posted March 16, 2013 The rain showers eased off mid afternoon today so I decided to get a little outdoors practice with my new TX200HC. I set myself up at an old solid table and chair and used a bean bag to rest my left hand on. With the rifles balancing point supported on my cupped hand and the stock lightly resting between my shoulder and cheek, I spent a couple of minutes watching the target rise and fall through the 10x scope as I controlling my breathing. All this bought back distant memories of forty years past, but then I had a .762 Parker Hale fitted with front and rear aperture sights and the rifle supported in a sling tucked behind my right upper arm and wrapped around my left wrist as I lay prone in the mud. After a little nostalgic reminiscence I loaded a .22 Air Arms Field into the breech of my TX200 in readiness. I settled into a comfortable stress free position, inhaled and exhaled a couple of times while I lined up the target, taking up the first stage of the trigger on exhale I held my aim and fired during the pause between breaths. As I watched the target during follow through, I saw the black paint chip off to the left of the yellow disc in the aperture of the knock down target 25m down range. I repeated the exercise several times and repeatedly hit to the left. A couple of days ago I had put away paper targets in favour shooting knock down targets, because I was disappointed in the way my pellets were grouping on paper, and after all I could hit the 35mm knock down targets a little easier. I thought I had better put out the paper again and re-zero the scope. After setting up paper targets at 25 and 35m; I settled down to fire off a few shots to zero the scope at the near 25m target. Although they were going to the left, surprisingly they made a very ragged one hole group. Six clicks on the scopes windage adjustment and two on the elevation adjustment bought the pellets perfectly to the aim point. At the 35m target I had to hold over by one and a quarter mil dot and make a two click adjustment on the scopes windage to produced a nice ragged one hole group on target again, although I did pull one shot and knew it at the time, with the pellet striking wide. For the first time since I bought the Air Arms TX I knew I had cracked the discipline needed to shoot it well. Perhaps not as well as in my earlier years but the satisfaction it gave me was beyond explanation and a much bigger rush than shooting any of the different PCPs I have owned. Regards, Steve 3 Quote Link to post
Skot Ruthless Teale 1,701 Posted March 16, 2013 Report Share Posted March 16, 2013 Well done mate. feels great doesnt it when you shooot a springer properly Quote Link to post
woodcote1 88 Posted March 16, 2013 Report Share Posted March 16, 2013 Good shooting. I think the HC is the nicest looking of the Tx series. Quote Link to post
Taz-n-Lily 62 Posted March 17, 2013 Report Share Posted March 17, 2013 Well done - your next mission, should you choose to accept it, is to dismantle the rifle and give it a mild self-tune and re-lube using the original parts. This will make the rifle smoother to cock and shoot, and the trigger goes from good to excellent when tuned. Quote Link to post
villaman 9,983 Posted March 17, 2013 Report Share Posted March 17, 2013 Well done mate ,have just picked up HW97 for £190 so I can get back into springer's Quote Link to post
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.