Fox tail perserving. Any ideas?
-
Recently Browsing 0 members
No registered users viewing this page.
-
Similar Content
-
By Rimfire Rifles Freedom
Hello all.?
Just an update as it has been a while.I have been looking for a subsonic .22LR hollow point that shoots well from a cold clean bore and have recently started using RWS subs which do well, typically from the first shot..I have used a few different brands of subsonic H.P.s and they all group quite well after 5 or so fouling shots, but RWS like the cold clean bore,needless to say I am a happy and for me, decent shooting.?.I have used the RWS before in the old Annie 1416 DG and it was equally consistent in that rifle.
A couple of typical below all from a cold clean bore..My scope is a Hawke Vantage x2 -x7 32mm A.O. with illuminated reticle which is a great field scope but lacks magnification for target shooting so is sometimes difficult to deduce if a shot has been pulled, but I love the scope.
Have a good weekend all.?
-
By Baldcoot
Due to a land change of use i now own a .270 Parker Hale. Very nice ,unmoderated light as and a 5 shot mag .
Zeroing next week, Mr Reynard is going to get a shock as are my ears
-
By Baldcoot
Well I got 2 unused table clamps and a need for stability.
Cant afford the new style tripods <on furlough pay>,so I thought make your own. So drill n tap m10x1.5 in the base of said bracket .
Cut 2 pieces 7.5x3.5cm steel plate and fix to clamp .Drill hole and fit split pin to stop wind out in turnscrew. Then cut leather patches to fit and bond with contact adhesive, allowing 24 hours to cure and Bob's your job.
Stable, free and hands free atb
-
By Sausagedog
While you were playing with your new rifles I went and got me a 3" hatsan ford escort 12g and to be honest I am quite impressed!
I put 28, 29, 32 and 36 gram loads through it and home loads some of which were subsonic and it cycled the lot! And with no O ring present!
I eventually did put an O ring on it but it was to thick and just would not allow the hammer to strike the firing pin although the action was locked. It's quite a precise fit. I later fitted a smaller section ring and now it fires. The reason for the ring despite perfect function without one is that the barreled action is quite loose without it but with it it all snugs up nice.
The one stock adjuster made it a perfect fit for me too. As autos go it is a pleasant cyclic sensation too, not effecting aiming much at all. It's no lightweight but not ridiculous either.
No pictures as it's just a cheap auto and I have been busy building an arc to survive the floods!!
Now, just got to wait untill September and hope the new world order movement don't get a knee jerk law passed banning duck and goose shooting one day before the season!
Oh yes, no oil in the action at all !
-
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.