Wanted hw100 adapter ?

[zuko 6]

Hi guys,

 

I am having an issue with the filling adaptor that screws into the gauge of my 3ltr air cylinder, the HW adaptor appears to short, when I attempt to fill, the air is escaping out of the small hole in the side of the fitting. Where am I going wrong

I have been trying to fill my hw100 bottle via the adapter below, Any ideas guys

 

Cheers.

[ol26 2]

I've got the old hw100, pre quick fill, so all charging is done via the bottle adapter. Dead easy. Just unscrew your bottle by hand from your gun, slide it out and screw into the bottle adapter attached to you bottle, and fill. Turn off main bottle and unscrew gun bottle. Self bleeding again. Then screw back into gun. Easy!

[telfs 8]

if you need one i have one for sale,pm me if needed

atb dave

[zuko 6]

I've got the old hw100, pre quick fill, so all charging is done via the bottle adapter. Dead easy. Just unscrew your bottle by hand from your gun, slide it out and screw into the bottle adapter attached to you bottle, and fill. Turn off main bottle and unscrew gun bottle. Self bleeding again. Then screw back into gun. Easy!

 

I have done what you said above but it's still kicking out air, the adapter seems to not be long enough to fill the threaded area on my filling bottle could this be the problem

 

Am i using the wrong fitting, What am i doing wrong

[ol26 2]

Umm..... You haven't lost an o ring from anywhere have you? I'll check mine later and update!

[GEOFF.223 83]

make sure inside the brass fitting the wee needle / male part is not loose as the work loose they leak alot of air.

 

 

if it a slow leak of fast ?