tilimangro 1,013 Posted October 9, 2012 Report Share Posted October 9, 2012 im going to start my knfe this weekend.its one of midnights blanks i want to do this thing justice so do you need to glue the lanayrd tubes into the knife handle or should it go in tight enough to just hold itself there and do you need to put a bit of glue on the corby bolts or are they going to hold themselves tight? sorry if these are totally idiotic Quote Link to post Share on other sites
the big chief 3,099 Posted October 9, 2012 Report Share Posted October 9, 2012 put glue round the bolts and whipe exess off the lanyard put a litle on the tube and put a nail punch in the hole use a hamer then widen them that should hold it in fine mate 1 Quote Link to post Share on other sites
tilimangro 1,013 Posted October 9, 2012 Author Report Share Posted October 9, 2012 thanks alot buddy Quote Link to post Share on other sites
midnight 657 Posted October 10, 2012 Report Share Posted October 10, 2012 you want lock tight in the thread of the corby bolts , that will lock them off . kevs right with the lanyard fitting , but i do mine slightly differant . just because if you crimp the tube wrong you have to cut the lot off and start again ! good luck with it im sure you will enjoy it !! this one has effectivly 8 miniature lanyard tubes in it , not one peened over , just shows there is lots of ways to go one with the job . 1 Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.