northernstalker 0 Posted September 18, 2012 Report Share Posted September 18, 2012 i recently purchased an ns200, i have several rifles i wish to use it on,however i have found that the two supplied rubber tubes to mount the camera module only fit a couple of my scopes,one being too large,the other too small. has any one else had this problem ? thanks Quote Link to post Share on other sites
PESCA 7 Posted September 18, 2012 Report Share Posted September 18, 2012 Could you not just use tape on your scope eyebell? George Quote Link to post Share on other sites
northernstalker 0 Posted September 18, 2012 Author Report Share Posted September 18, 2012 hi george, yes i could, however the tube that does go over the scopes in question, is very loose,and would need a great deal of wrapping. i have sent a question to nitesite, waiting for a reply thanks tom Quote Link to post Share on other sites
BLACK-GUN 94 Posted September 19, 2012 Report Share Posted September 19, 2012 hi george, yes i could, however the tube that does go over the scopes in question, is very loose,and would need a great deal of wrapping. i have sent a question to nitesite, waiting for a reply thanks tom Hi Mate, i had the same problem until i purchased a NV Challenger Dos Adapter off ebay for £38 now i can fit it to all my scopes. Joe. Quote Link to post Share on other sites
northernstalker 0 Posted September 19, 2012 Author Report Share Posted September 19, 2012 thanks for that,i will take a look cheers tom Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.