chairgun

[paulk73 151]

is it possible to print off scope cover labels from the chairgun software??? im struggling at the min. any help would be great. thanks

[BenjaminCadd 109]

If you use Hawke BRC you can, right down to an inch, i find it easier to use than chairgun aswell.

[paulk73 151]

can you still put all the relavent info in, to get the correct calculation??

[Phantom 631]

Open CGP

 

Click "Tools" then click "Lables Etc" then click "Scope Caps"

 

Chose colour and size and thats it

 

Tony

[paulk73 151]

can the reticle be printed off tony or is it just the wheel format???

[Phantom 631]

Using the instructions I gave you, it will print the ret with the ranges on each point.

Once printed, simply glue it to your scopecap.

Using the other lables you can do turret tapes and range cards as well.

 

Tony

[BenjaminCadd 109]

can you still put all the relavent info in, to get the correct calculation??

 

Yes you can, dowload it and have a look, i find it easier and less clutterd!

[ghillies 209]

hmmm lol i likes this set up. (with the barrel mounted laser).

 

'tools'

 

'labels etc'

Edited September 15, 2012 by ghillies

[secretagentmole 1,701]

I just get it to 5m steps, leave it at that mag setting after checking points of impact, leave it at that!

[ghillies 209]

thats the chappie.

[paulk73 151]

cgp wont let me do this for some reason???

[Phantom 631]

How far do you get?

 

Any Error messages? If so what do they say?

 

Tony

Edited September 16, 2012 by Phantom