Phantom 631 Posted June 28, 2012 Report Share Posted June 28, 2012 Hey up Chaz Remember that piece of scrap that I bought for a tenner at the meet? Well on the first bulb of Co2 it went from 4 to 0 ft/lbs in 17 shots and had gas venting on my hand with every shot! A few hours work, a bit of TLC, few more quid spent and a polish inside, turning the seal's around and I now have this: "The Black Rat" Multi shot It's running at a reasonably consistant 5.75 ft/lbs with RWS Superdomes. Tried both heavier (Bisley Magnums) and Lighter (RWS Hobby) pellets and they all bring about a reduction in ft/lbs. As it has a detachable stock I'm keeping it below 6 until I get the stock fixed then a heavier hammer spring and slightly longer barrel will bring it up for field use. Thanks again Chaz, it was a really great bargain Tony Quote Link to post
gurtwurz 792 Posted June 28, 2012 Report Share Posted June 28, 2012 that looks mental tony!! should make a great close range ratter, and if not, then james bond'll probably take it off your hands... cheers, wurz 1 Quote Link to post
tomano1 80 Posted June 28, 2012 Report Share Posted June 28, 2012 Should have done a before and after mate but if u have put that much in it looking good Quote Link to post
Phantom 631 Posted June 28, 2012 Author Report Share Posted June 28, 2012 Should have done a before and after mate but if u have put that much in it looking good It was just a leaky pistol when I got; Hence it cost me a tenner I got a couple of 'job lot' bits including the multishot breech and clip, three bolts, stock, laser, scope mounts, the forgrip and seals for a pittance and I've also got a standard stock in cammo. I've also got a Terry Robb extended breech and probe etc... Tony Quote Link to post
Mawders 595 Posted June 28, 2012 Report Share Posted June 28, 2012 Not my cup of tea tony but well done for fixing it up at such a low price. Quote Link to post
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.