1st go at a natural catty

[the big chief 3,099]

just been out with this catty it shoots brilliant with marbles but i had some 12mm lead balls and the single band i have put on just wasnt right for lead balls the ammo was too heavy for it i found so guna get a load of marbles for this one.cheers atb kev

[Run_Rabbit85 8]

if you wanna fire 12mm leads buddy try dbl therras taperd 20mm to 15mm atb

[the big chief 3,099]

if you wanna fire 12mm leads buddy try dbl therras taperd 20mm to 15mm atb

i use doubles on my other but only had single spare i will just use marbles with this catty

[Run_Rabbit85 8]

ok buddy do you use straight cut or taper 25mm to 20mm? a lad i no has been doing abit of experimenting with the crony and found that a 20mm to 15mm taper generates the same power as the 25mm to 20mm just with an easyer draw he sent me afew band sets to try and find the new taper alot more easyer to work with as ya dont get the hand shake when at full draw or even with singles cut them down to about 6inch pouch to fork and still nock game stone dead atb mate

Edited April 22, 2012 by Run_Rabbit85

[the big chief 3,099]

i don't no what they are mate they where made by rk catapults so you would have to ask rob on that front . they measure 8" to the pouch so i think i will have to take some off and re tie them

[shellfish 63]

you cant beat the square elastic imho used to make my strag out of privet bang on

killed plenty of game all the best with it gaffer more satisfaction using a catty

[the big chief 3,099]

i am a convert from square mate flats seem to be better for me

[Run_Rabbit85 8]

flats last longer and are twice as fast as the square. if ther of rob they will be 25mm to 20mm gafer just orderd another catty off him cnt fault his craftmanship will only buy off him and gamekeeper john. if ya tie them down to 6inch without cutting them if that lenght dnt work for you ya can always retie them to what ever suits without wasting the band set mush when i used singles with lead ammo at the standerd length they came in they was great for 9.5mm steels target plinking but hunting they didnt seem to knock oat down with a body shot so cut them to 6inch and what ever game i hit even bunnys they did the trick

[martin 332]

oUT WITHE DOGS TODAY AND SAW THIS ONE HERE,WOULD IT MAKE A GOOD ONE?

 

[Run_Rabbit85 8]

should do mate i tend to cut the thicker ones then shave it down a wee bit give it a good sanding and a good few coats of spray polly leave her to dry band her up and of we pop job done