dogvixen01 34 Posted December 2, 2011 Report Share Posted December 2, 2011 advice wanted to find out how to change the pellet probe seal on my aa s200 .i have had varying fps / ft lb readings on the gun and as it is regulated i have been told it may be the seal requires replacing. i have tried googling the problem ,without much success .any advice very gratefully received.thanks.atb. Quote Link to post
Phantom 631 Posted December 2, 2011 Report Share Posted December 2, 2011 Piece of cake, get the ring from Chambers http://www.gunspares.co.uk/shopdisplayproducts.asp?id=24235&cat=S200 Then cut the old one off (gently). Soak the new seal in warm water to soften it, and use a blunt needle to then prize the ring over. If you can't do it that way, then there is the "Propper" way! Bit of a long drawn out proceedure, but I can help you out on that if needed. Tony Quote Link to post
davyt63 1,845 Posted December 2, 2011 Report Share Posted December 2, 2011 hi Russell you have PM I wouldn't put a pin in to any seal, but only to remove it! Davy Quote Link to post
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.