blackcat 0 Posted July 21, 2011 Report Share Posted July 21, 2011 hi guys im haveing trouble with my new scopes and one piece mounts ,i have zero it fine ,shooting straight no probs ,but i have max out at 20 yard and it wont click any higher?any one can help please Quote Link to post
secretagentmole 1,701 Posted July 21, 2011 Report Share Posted July 21, 2011 Tried swapping the mounts round? If not you will have to shim it! Quote Link to post
java53 30 Posted July 21, 2011 Report Share Posted July 21, 2011 Had same trouble with my bsa super sport had to get a pair of inch high mounts sorted. Quote Link to post
Tic Tac 0 Posted July 23, 2011 Report Share Posted July 23, 2011 Easy peasy before tightening the scopes up on mounts slide the scope back or forward all depends on the where the position of the scopes are if they are forward then loosen the mounts which holds the scopes and slide it the opposite direction then tighten them back up job done! Quote Link to post
nichard 4 Posted July 24, 2011 Report Share Posted July 24, 2011 I had the same trouble with me Hawke nite eye. No matter where I positioned it or swapped the single piece mount around it was too low on max elevation. I made a thin shim out of some aluminum and placed it under the scope on the rear of the mount. This raises the back of the scope up and the cross hair down. Scope is bang on now Quote Link to post
mikeyblue 28 Posted July 25, 2011 Report Share Posted July 25, 2011 As already mentioned try switching the mounts round. If that doesnt work and shimming is required I find that a few slivers camera film negative works well. Mikey. Quote Link to post
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.