chipper 2 Posted May 19, 2011 Report Share Posted May 19, 2011 ive been setting my long net and leaving it loose at the bottom is there a way you should atch the poles Quote Link to post
Tiercel 6,986 Posted May 19, 2011 Report Share Posted May 19, 2011 What type of poles are you using? GRP or Hazel? Is the net pre set or traditional? TC Quote Link to post
chipper 2 Posted May 22, 2011 Author Report Share Posted May 22, 2011 What type of poles are you using? GRP or Hazel? Is the net pre set or traditional? TC im using hazel poles i just set the net and poles when im out ive never used them before last season just liked the idea of them on big rabbit sets Quote Link to post
fidodido 30 Posted May 22, 2011 Report Share Posted May 22, 2011 wrap bottom line round peg first before sticking in ground Quote Link to post
Tiercel 6,986 Posted May 22, 2011 Report Share Posted May 22, 2011 (edited) This is the method I use for hazel pegs. On the bottom line you wrap the line around the peg once. On the top line you make a clove hitch. You make the clove hitch like in the next three very poor photos. Make your first loop and make sure that the line that is in your hand is on the under side of the loop Next while still keeping tension on the loop create another loop in you hand, then pass it over the top of the peg. You now have a clove hitch around the peg and that will not slip down the peg. Don't put too much tension on the foot line but as much tension as you can on the head line. Hope that helps. TC Edited May 22, 2011 by tiercel 1 Quote Link to post
chipper 2 Posted May 22, 2011 Author Report Share Posted May 22, 2011 thanks lads al do this next time i use them 1 Quote Link to post
TRF-JRs 6 Posted July 29, 2011 Report Share Posted July 29, 2011 This is the method I use for hazel pegs. On the bottom line you wrap the line around the peg once. On the top line you make a clove hitch. You make the clove hitch like in the next three very poor photos. Make your first loop and make sure that the line that is in your hand is on the under side of the loop Next while still keeping tension on the loop create another loop in you hand, then pass it over the top of the peg. You now have a clove hitch around the peg and that will not slip down the peg. Don't put too much tension on the foot line but as much tension as you can on the head line. Hope that helps. TC I was curious too - Handy advice that, thanks a lot Quote Link to post
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.