mark@mbb 31 Posted February 6, 2011 Report Share Posted February 6, 2011 hello lads i have cut a metal taret out of 20mm plate and it is going to have a 6" plate over the engine room painted white which can be removed and repainted the fox has been painted with red primer Mark Quote Link to post
lampingboy 213 Posted February 6, 2011 Report Share Posted February 6, 2011 good job mate,are you planning on selling these ? Quote Link to post
mark@mbb 31 Posted February 6, 2011 Author Report Share Posted February 6, 2011 Not sure mate i have made two one was a red stag and the other is charlie but the cost was around £100 so i dont think there would be a market in todays economic climate but who knows mark Quote Link to post
dave1372 83 Posted February 6, 2011 Report Share Posted February 6, 2011 That looks great ! I imagine the postage would be a bit on the pricey side with the weight of it . Where do you live you may get some local guys interested? Quote Link to post
danebrewer10 6 Posted February 7, 2011 Report Share Posted February 7, 2011 did you use a plasma cutter on those? I guess that is hardened steel? else I can see it getting beaten up pretty bad I think they tend to curve after a lot of use and you have to turn them round... I'm not sure on that, just sth I heard someplace. but if it's 20mm plate that'll weigh a ton!, but nice work! Quote Link to post
HUnter_zero 58 Posted February 7, 2011 Report Share Posted February 7, 2011 Cool! I've always wanted a Rod buck steel target. John Quote Link to post
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.