Barrel thread.

[Jane Doe 0]

Does anyone know where I can get a barrel threaded to accept a Moderater in the N.Derbys/S.Yorks/Peak area? Thank you for reading. J.H.S.

Edited June 30, 2010 by Jane Doe

[Phantom 631]

What gun you thinking of threading?

It may be cheaper and less hassle getting an adaptor for it?

 

Phantom

[stevieskin 4]

A&M Custom would do it for you.

Its about half hour drive from Chesterfield if that helps you.

 

http://www.amcustomgunsmiths.com/

[Jane Doe 0]

A&M Custom would do it for you.

Its about half hour drive from Chesterfield if that helps you.

 

http://www.amcustomgunsmiths.com/

Thank you. I'll check out the site tomorrow. Looks promising. Just got in! Regards. J.H.S.

[Jane Doe 0]

What gun you thinking of threading?

It may be cheaper and less hassle getting an adaptor for it?

 

Phantom

I am sure it would but I have tried that method before and was not impressed. That said, thank you for taking the time to reply. J.H.S.

[Jane Doe 0]

A&M Custom would do it for you.

Its about half hour drive from Chesterfield if that helps you.

 

http://www.amcustomgunsmiths.com/

You were dead right. Sent Dad over with the S200 this a.m. Took him less than an hour to get there. Mandy made him a cup of tea whilst Adrian threaded the barrel and put a few rounds through it to make sure it was ok. The service was excellent and a fraction of the cost other Gunsmiths were asking. I would recommend him to anyone, he's a true enthusiast and totally genuine. Regards. J.H.S.

Edited July 2, 2010 by Jane Doe

[stevieskin 4]

I am glad to hear you got it sorted out , and in quick time too.

[Phantom 631]

I use an S200 and use both (depending on my mood) the slip on silencer (heavily modded and darn quiet) and I have a unf adaptor for the S200 for when I like to use my UKNiel Silencer

 

The adaptor was cheap, but having heard what you've said about having the barrel thread cut, I may go down this route myself later on

 

Phantom