BI-POD FITTING

[chris strilciw 1]

hey all as it says i will be ordering a harris 9-13 tilt and swivel bi-pod in the next few days and want to attach a sling to it as well so was wondering wat studs are good and any tips advice on fitting and its on alice my s410

 

cheers folks chris

[Bootsha 1,306]

Hi Chris

 

The studs I used to use are the screw in type with a quick release opening on them. Just be carefull when you screw them into the forend that the tip of the thread doesnt go to far through and touch the barrel, or is close enough to touch it when its rotating on firing, especially if you have a fully floating barrel. You may have to trim the end of the screw part. Hope this helps mate.

 

ATB

 

B

[chris strilciw 1]

cheers mate can you take the air cylinder out of the s410? just so i know i wont touch it if its on then i know

 

chris

[markha 99]

Chris,

There is only one allen head bolt that holds the stock in place on the 410, its just infront of the trigger guard. If you take the stock off you will be able to check how thick it is at the point where you intend to put your swivel for the bipod/sling.

 

Im also thinking of doing the exact same thing with my 410, and have had a google around for QD swivles and will be watching this thread to see what comes up.

atb

Mark

[chris strilciw 1]

cheers mate good to know just need to find out what stud to get and thats me sorted

 

chris

[chris strilciw 1]

come on people help lol

[venomviper 129]

hi ya buddy

i hope this helps you if not give me a pm in the morning and we can go from there buddy

 

shay

[chris strilciw 1]

thats spot on mate any prefrence to studs?

 

chris

[venomviper 129]

thats spot on mate any prefrence to studs?

 

chris

hi ya chris

yeah QD studs buddy

 

pm'd you as well matey if that helps to

 

shay