hw100

[greengrass382 0]

hi ive got a HW100 22 ive just discovered a little air leak comming from the end of the bottle where i screw it into my gun i have the old type bottle not the quike fill was wondering if i could just take the end bit off n replace a seal or something or do i buy a new quike fill bottle??? if i brought a quike fill bottle would i have to buy a divers tank and all the trimmings too? i use a hand pump at the moment havnt really got the money to splash out on all new gear if i can just have this bottle repaired? any help or advise would be apprecitated thanks

[stealthy1 3,964]

Take it to your local gun shop and ask them to check the seal on the bottle, if your skint it may be a bad idea to go for the quick fill bottle as they're a bit expensive

[greengrass382 0]

yea will do cheers was hoping i could repair it rather thn replace the whole bottle

[Guest Scuba1]

get all the air out of the gunand take the bottle off then nipp over to B&Q and get one of those o-ring sets. replace the o rings and Bob is your mothers brother.

 

HTH

 

Michael

[greengrass382 0]

ive just looked inside the bottle where i screw it onto my gun ..there is a little brass nipple should there be a o ring on there cause there isnt? tht could be the problem:)?

[davyt63 1,845]

ive just looked inside the bottle where i screw it onto my gun ..there is a little brass nipple should there be a o ring on there cause there isnt? tht could be the problem:)?

do you mean the brass filling adaptor?,if so then yes there should be a Oring on it.then if still lossing air do as mike says,but make sure you use your decanting adaptor to take all the air out of the cylinder

hope this helps

regards

 

davy