Jump to content

how far should i have my .22 zero'd for?


Recommended Posts

hi guys i have a CZ452 .22LR and im using RWS subsonic ammo and i hjave a few questions:

 

what is the general distance people have their .22LR's zero'd at

 

currently im at 50 meters is this any good?

 

is there a flatter shooting subsonic round i could use?

Link to post

hi guys i have a CZ452 .22LR and im using RWS subsonic ammo and i hjave a few questions:

 

what is the general distance people have their .22LR's zero'd at

 

currently im at 50 meters is this any good?

 

is there a flatter shooting subsonic round i could use?

 

 

Most have them zeroed with subs at 50-60 yards as said, but the simple fact is zero as well as you can shoot it, and at a distance that best suits your land!!

 

Subs tend to fly at a very similar speed, and many are 40g so there is little or nothing to chose between any of them by way of an arc, but each barrel will have a favourite round and some are just more accurate, more consistantly, than others!!

Link to post

I am about the same as the V......

 

Work out where your targets are likely to be and where you want to shoot from.

 

Pace it out, then go and play with some paper at similar distances, put one target 20 paces nearer and one 20 paces further and work out where this is on milli dots or clicks on the turrets!

 

I like Eely subs.

 

CBW

Edited by cbw
Link to post

50 Yards for me to! On my Leupold VX3 LRT Varmint ret when the centre cross of the ret. at 50 yards is spot on, the next 'rung' down on the ladder is dead on at 100 yards, (which was nice).

I think ammo is the key to the .22.

I mostly use Winchester Subs or RWS, both are very consistent and if mixed up I can't tell the difference.

I used to get some Magtech (from Brazil) a few years ago (massive hole in the hollow point), these were cheapo' but every bit as good as the other two, but haven't seen any for ages?

I have used Eley, and they are fine as well, but the bullets are dipped in paraffin wax which picks up any fluff or grit, so if you dont keep them in the slide lid box and load from there they get gunged up easily, also the wax gets on the breech/bolt and in the guts of the magazine.

Remington Subs are cheaper than most and shoot fine, but I got lots of 'runners' and ricochets using these, I think the bullet lead alloy is too hard and the hollow point too small, they bounce off anything but soft mud and just go straight through rabbits?

Anyhow, I have found very little .22 ammo that is really rubbish, a duff box or batch comes around here and there, but I have never had any bad Winchester or RWS and I have burned off 1,000's over the years.

Also I have had a chronograph for a few years now and have checked out the velocity figures for all of the above, and to be honest compared to my hand loaded centrefire ammo, rimfire is really poor, even the dear stuff varies by as much as 40 to 60 f.p.s. however it does not appear to reflect in the accuracy department, (most subs shoot around 975 to 1020 f.p.s.). Cleary not so critical on slow old lead bullets!

Link to post

The chart I saw for Winchester subs gave 59 yds as being optimum, so 60 seems right. It doesn't matter really as you soon learn to compensate automatically anyway.

 

Try the mainstream alternatives to winnys as my last 3 .22s have all shot more accurately with Eley. ;)

Link to post
I am about the same as the V......

 

Work out where your targets are likely to be and where you want to shoot from.

 

Pace it out, then go and play with some paper at similar distances, put one target 20 paces nearer and one 20 paces further and work out where this is on milli dots or clicks on the turrets!

 

I like Eely subs.

 

CBW

 

 

Good advice you won't go wrong with this,.

Link to post
This has been asked before think everybody agreed 50/60 yards and the most popular was Winchester subs

i got a cz 452 and i bought winchester and all i had was them jamming couldent do anything with them i use remmington subsonic and i zero about the same 50/60 yards

Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...