jumby

Any one got any options on these scopes was going to get one 3x12x56 had good and bad reports

hi after the dvd foxing if any one can help me out?

milky doe

there is also one on gate netting hares

it was a little ridge i am going to try it tommorrow dan hopefully it will b alright if not it will have to go to the gunsmithes atb trevor

i have removed the stock and there was and obstruction i sanded it down lightly and put back on the £10 passes right trough to the action now going out on friday to test it will let you know the results

ok mate i did not clean it before i missed the roe i had shot quite a few roe prior to missing the last one i have a mate who has the same gun and he says to put a £10 note in the foreend and it should slide down between barrel and stock to the actioni have tried this and mine only goes about 4 inches

ok mate thanks for your comments i have cleaned it took the moderator off and checked that using the same ammochecked the mounts and checked the moderator the only thing i have not done and thats the scope

i think it might be the barrel i was told to slide a piece of paper down the fore end and it should slide down to the action mine only goes about 4 inches

its a 243 with as swarvoski scope mate

just wondering if any one has had any problems zeroing this model ive had it approx 12 months gun s been bang on went out last sunday missed a roe by a mile thought i had maybe knocked the scope so went out on sunday to re zero it and my ist shot was a good 10 inch of the target finally got it spot on went pout today had a shot at yds and missed it clean had a shot at my target which i had in the van and it was out again any ideas would be greatly appreciated atb teejay

where abouts are you mate?

the 1st one is used to get clinker out off coal boilers

in very good condition by frank sheardown £7 plus £3 p&p from east yorks

£30 in east yorkshire